Second-hand housing decoration renovation knowledge of second-hand housing after finishing considerations

In today's high prices, the purchase of second-hand housing, will almost always be renovated, second-hand housing is favored by more and more owners, so second-hand housing decoration has become a major topic in the decoration industry. The decoration of second-hand houses is actually more indispensable than the decoration of new houses, and the price of renovation of second-hand houses will be 10%-20% higher than that of new houses. There are a lot of available parts in the original decoration of second-hand housing. If you maintain the current status of this part of the renovation or minimize changes, you can save a small amount of money. Therefore, before the renovation, we must first do enough homework to understand what the old house needs to pay attention to in the process of changing the face.

Second-hand housing renovation process

First, you must first prepare the tool before the decoration, you must prepare a few things in your bag: tape measure (buy 5m, not 3m), calculator, large board clip (slip list, receipts used). Specific usage can refer to the online second-hand housing renovation diary related content. The selection of tools in the second-hand house renovation process must be ranked first, as the saying goes, the sharpening knife is not a mistake. It is best to prepare old towels (the kind of soft cotton, bricks used for rubbing bricks) and plastic bags on the construction site in advance, and wrap them around the pipe joints to prevent dirt from clogging.

Second, clarify the area involved in the renovation process.

Before the workers enter the court, it is best to measure the corners of the house in person, take them down, mark them clearly, and be sure not to be lazy. The contents of the measurement mainly include: the area involved in the decoration process. Especially the tiling area, wall paint area, wallpaper area, floor area; clear main wall size. In particular, it is necessary to design the wall size of the furniture later. Second-hand housing decoration considerations The measurement of the size must be precise, and the material needs to be more pre-measured.

Third, the main demolition reform

The demolition of the main body is the first one to be put on the project. It mainly includes the demolition of walls, walls, shovels, removal of heat, replacement of steel windows, and so on. After the demolition of the completed garbage, it must be cleared up in time to ensure the cleanliness of the interior, but also to facilitate the construction. In the second-hand house renovation process, the finished product door should be settled at this time. At this time, it is better to put the cabinet, the smoke machine, the stove, and the water heater through and confirm it.

Fourth, we must carry out the reform of hydropower

The second-hand housing decoration matters need to be modified in strict accordance with the provisions of the hydropower, otherwise there is a safety hazard. Before the hydropower reform, the cabinet designer should come to the door to make the first measurement and help you determine the power and waterway reconstruction plan. Water heaters, it is also best to send someone to design the location of the power supply and the interface according to the model you have determined. In the second-hand housing renovation remind you that the wall below the basin, it is best to leave the power outlet, easy to install kitchen treasure. The air-conditioning hole and power source should be placed on the wall of the bedside as much as possible to avoid air-conditioning blowing directly to people. Strong and weak electricity should be kept at a distance of 20 cm. For example, a distance of 20 cm should be left between the outlet and the cable.

Fifth, pack the tube

Considering the wet and damp environment of the kitchen and toilet, the material of the standpipe must not be wood keel! Everyone must be careful, even if the wooden keel brush anti-corrosion coating does not work. In the second-hand house renovation process, remember to use light-gauge steel or red brick for the standpipe. Light steel keel provinces, but the most solid and easy to use is the red brick. At this time you need to buy a good tile, caulking agent, etc., furniture should be set early, leaving a good duration, generally at least 15 days or so. To add, don't wrap the pipeline in the place where the access is to be found. In case of seepage, no reason can be found.

Sixth, tiling, the first thing with a solid texture

According to the second-hand housing renovation diary, before tiling, to buy a good floor drain. To buy a dedicated washing machine or shower floor drain, but also to deodorant function. After finishing waterproofing and pulling hair, prepare a tiling. Second-hand housing decoration notes of the tiles, tiles soaked in water, dry; broken tiles left to do cutting, please buy before the bricks to play a wealthy amount. At this time, basins and faucets should be determined, and cabinet designers should be invited to visit the house for the second time. At the same time, they should purchase paint (mixed or clear), wall paint, lacquer, diluted water, etc., as well as wallpapers.

Seven, brush paint

Brushing the wall in the second-hand house renovation process is the main process. It is generally through the process of leveling, grinding, rolling brush, the effect is good or bad, absolutely rely on the craft of your oil workers. Through a lot of second-hand housing renovation diary to remind everyone that if the wall to brush color, color must pay attention to the color of the call out than the color card light, do not be the same as the color card or deeper than it, or you will regret it . Because at least two coats of paint are used to paint the walls, some of them are still three times. The color of the wall will be deeper than the one layer. The method of painting is spraying or roller coating. The benevolent sees the person and the wise sees the wisdom. It is said that the effect of spraying is better, but once it is destroyed, it will become difficult to repair the paint.

Eight, wallpaper work

After the wall paint is brushed, the oil trader will apply nitro-lacquer to the place where the wallpaper is to be applied. The paint can dry after the next day, and then the master can paste the wallpaper. At the beginning, I was worried that the wallpaper would dirty the painted white wall. I knew it later when I posted it, and the wallpaper was really a special clean job! Worry completely redundant.

Second-hand housing decoration Note: wallpaper paste within 48 hours do not open the window ventilation, let it slowly dry. Say good to the master, if there is an odd place in individual places, trouble him to repair it. At this point, buy the panel, socket, lamp.

Nine, install the socket panel

1, the best outlet to buy with a switch function, especially the kitchen, so that rice cookers, microwave ovens can be removed from the power supply, with the switch to control.

2, although there is a good switch socket, but pay attention to practicality.

Tenth, kitchen ceiling, seal the last ugly part

First install the water heater and Yuba, after installation, the ceiling edge can be better half-package water heater, which is more beautiful convergence. It is best to buy aluminum buckle ceiling, even if it is removed after many years, selling scrap aluminum is worth a lot of money. On the other hand, pvc buckles look good, but the quality and performance are generally the same, and plastic things are worth a few dollars even if they sell waste. Buy buckle board, to ask the price of all-inclusive, do not buckle board, corner to buy. But the installation fee is another calculation.

After second-hand housing completion notes

First, the waterway project can not relax

The waterway must be thoroughly inspected. If there is a water pipe aging, it must be replaced immediately, and the layout of the water pipe is also reasonable. Before decorating a second-hand house, a 24-hour to 48-hour water storage leak test should be conducted on the bathroom and kitchen to check how well the original waterproofing project is done. If there is no water leakage, it proves that the waterproof treatment is done well; if there is a leak The phenomenon must be re-waterproof.

After the waterproof treatment is finished, wait for the ground to completely dry out, then lay the tiles and perform the overall renovation. Moreover, when the toilet is changed, the waterproof treatment of the position of the toilet should be done well. When designing and decorating the top of the toilet, attention should be paid to convenient disassembly and assembly, which will facilitate future inspection and maintenance. At the same time, it should be noted that no dead corner can be left after construction.

Second, circuit transformation can not be ignored

Second-hand housing generally has the phenomenon of simple circuit distribution, aging of electric wires, illegal wiring, and so on, which can no longer meet the electricity demand of modern households. Therefore, it must be completely rebuilt and rewired during the renovation. If it is found that the original line is an aluminum wire, it must be replaced with a 2.5 mm square section of copper wire. For the installation of air-conditioning and other high-power appliances, a 4 mm square section of the line should be set up separately, and a PVC insulated conduit should be used when embedding.

In addition, the new national standard stipulates that the number of fixed sockets in civilian houses should not be less than 12, but there are still many existing second-hand housing outlets that do not meet this standard, if a large number of mobile sockets are used, when the current load When it is increased, the mobile socket will cause abnormally high temperatures due to poor contact, thus burying hidden dangers for electric shock and electrical fire accidents.

Third, "hidden project" to open again

At present, a large part of the quality problems in home decoration is caused by the improper construction of “hidden projects”. What is a "hidden project"? In the construction process sequence, the work of the previous process is over, and the site that will be covered by the next one and cannot be inspected is called a "hidden project." Therefore, in the second-hand housing renovation, we must pay special attention to "hidden projects." For example, whether the pipelines, lines, and equipment of various facilities such as water supply, air conditioning, and ventilation in the ceiling have been subjected to closed tests and electrical insulation and resistance tests, whether the connection is firm, whether the joint practices meet the requirements, and whether the flammable materials have been fire-resistant. Combustion treatment and so on are all within the scope of “hidden projects” and are no longer inspectable after the first installation.

Fourth, three "face" transformation is essential

At the time of renovation, renovation of the wall, floor and ceiling of the second-hand house is also very important. Experts suggest that it is advisable for professionals to conduct on-site inspections of the houses to see if there are any obvious cracks, whether they are smooth, free from falling off and sanding. If these conditions exist, repairs must be carried out, including the removal of wall-fouling, powdered wall paints, etc., and the use of cement mortar to repair foundations, cracks, and holes. In addition, the primer should be covered with a primer after the repair, so that the base layer can be firmly secured. Secondly, changes in the base layer due to efflorescence and moisture can be prevented in the future, and then the latex can be diluted with a proportional dilution.

Fifth, carefully consider the update of windows and doors

Aging doors and windows is also a prominent issue in second-hand housing, but if the material is strong, and you also like its style, in general, as long as the repainting can be a new look, but if the following problems arise, you must remove the redo, the main The question depends on whether the wooden doors and windows are skinned and deformed. If so, it indicates that the characteristics of the wood itself have changed and must be replaced. In addition, the surface of steel doors and windows falling off, the main body rust or cracking, in addition to unsafe, it is difficult to restore the original state, in order to not affect the use of results, experts suggest that should be removed to redo.

Six, pay attention to three points when dismantling the decoration:

1. When smashing wall tiles and floor tiles, avoid clogging the sewers with debris;

2, handle the waterproof, waterway use elbow as little as possible to avoid poor or blocked flow;

3. Minimize the use of wooden boards. Most wooden products contain formaldehyde, which affects health. In addition, the wood will be deformed due to the weather, and the manual cost of wood products is also higher.

Seven, second-hand housing to be completely disinfected

Renovating a second-hand house is an essential step that must be thoroughly disinfected. It can be sprayed with 3% lyosol, 1%-3% bleach water, or 3% peroxy acetic acid solution. Sprinkle doors and windows 1 hour after spilling.

Editor's summary: The above is about the second-hand housing decoration renovation knowledge, second-hand housing after completion of the relevant information, for reference only, and hope to be helpful to everyone. If you want to know more related information, you can pay attention to this website information.

Decoration

ABS Solid Color Edge Banding

1.Adopt quality ABS resin raw material, imported UV. 2. ABS solid edge banding have matt+high gloss+emboss finish surface. 3.Customize size and color.size range from 0.35-3.0mm thick and 12-620mm width. Above 98% matching to customer`s standard panel. 4.Eleven years ABS manufacture experience. 5.Strict quality control system; well after-sales service are promised:strict test during every step of ABS Edge Banding produce. 6.Won high praise from cooperated customers 7. We promise to only offer high quality edge banding.

ABS Solid Edge Banding Series

ABS Solid Color Edge Banding

ABS Solid Color Edge Banding, Solid ABS Plastic Edge Banding, Furniture Solid Color ABS Edge Banding, ABS edge banding single color, unit color ABS edge banding

Sinowolf Plastic Dekor Co., Ltd , http://www.sinowolfdekor.com